new Sienta install drive recorder DRY-WiFiV3

Drive recorder position determination

I am on the new Sienta HYBRID G White Pearl.

I bought Yupiteru 's drive recorder. Let's install it first. I got lost a lot about where to install the front windshield.
Whether it is on the driver's seat side or the passenger's seat side, or on the right side or the left side with respect to the seat ...

After all, like the first picture, I decided to install it on the left side of the driver's seat. The point here was ...

· This position is the position where the power cord is most unnoticeable
· Position where the wiper passes in consideration of the rainy day
· You can always check that it is working

It was such feeling. Since the power cord comes out from the left side of the drive recorder, When trying to make the power cord in a not noticeable position, I think that I will definitely be on the left side against the seat. And, on the left side of the passenger seat, When trying to comply with the rule (law?) That it must be attached to the upper 20% position, It could not be attached to the position where the wiper passes. So it is inevitably in this position.

I was lost as to whether to paste with double-sided tape on the black dots on the center of the windshield, Again stuck on the black dots, we adjusted it to the position where this black dots are not reflected on the camera (If something is told at the time of a car inspection, I wonder if there is only to repack it (^ _ ^;)).

Somewhat undisturbed position of satisfaction

Actually, I tried running for a few days, as to whether there is no problem in the state attached to this position. Whether this attachment position feels disturbing depends on the feeling of each individual, I did not feel disturbing at all. And it is nice feeling because you can easily check that it is working.

The liquid crystal display of the drive recorder has a setting that the screen disappears in 1 minute or 3 minutes from the power ON, I set it to disappear in 3 minutes (of course, the recording is continuing). I wanted a feeling of running (¯ ー ¯) If the red lamp on the bottom right of the LCD is on, you can see that recording continues even if the screen is off.

Power supply is in a direction not using cigar socket.

For the time being, without hiding the wiring of the power cord, it hangs down over the room mirror, I was running in a cigar socket
... In this state, the code is disturbing more than I expected (^ _ ^;) After all, I made up my mind to conceal all wiring in my lining. Since I want to take a power supply without using a cigar socket, After all I decided to buy Jupiter's genuine power cord.

ユピテル USB電源直結コード OP-E487

Other than Jupiter genuine, there are some more cheap, but it did not move! There are many things that have an evaluation of saying, Because it is about 1,500 yen even genuine, I decided to buy a Jupiter genuine Yahoo ringtone. Mini USB connector part, It is good that the angle is attached to 90 degrees, because it seems that you can make the chord more inconspicuous (^ _ ^)

↓I ordered it with amazon, and it arrived about the next day. The code seems to be long enough.

↓The box of the converter is unexpectedly large ... You have to think about where you put the luggage in the position (· ·;)

↓This was the only instruction, but this may be enough. I also have a fuse properly.

It was confirmed this time that positioning of the drive recorder and proper recording can be done! Since the code which can be directly connected to the 12-volt Sienta's power supply is complete, next time, try hard and wire it (?), I think I will make it clean! (^ - ^)
Drive recorder wiring hidden