new Sienta install cruise controll pivot 3-drive･α

Cruise control, I bought it

I am on the new Sienta HYBRID G White Pearl.

I was looking for a cruise control that corresponds to TSSC (Toyota Safety sense C).
I checked it with pivot by e-mail. I also confirmed that it corresponded to hybrid TSSC surely, so I finally bought it!

When I bought it, I bought it at Rakuten because it was Rakuten free shipping and was out at 21,654 yen. Because it was cheap 2 or 3 thousand yen from other Rakuten listings and Amazons, I was a bit worried whether it was really okay, No doubt, the body for the new Sienta hybrid TSSC and its corresponding harness have arrived. The dedicated harness is mandatory.

pivot 3-drive･α Harness set （3DA-C+TH-11A）Collision mitigation system car only
トヨタ ノア・ヴォクシー H28.1- ZRR80/85W 3ZR-FAE ハーネス品番：11A ブレーキハーネス品番：設定なし

Surprisingly few parts count

↓Here is the inside of the main body. Surprisingly the number of parts is small. Cruise control main body, its controller, Harness etc. Since it was prior information that the instructions are solid, this explanation is expected (o ^ - ^ o)

↓Cruise control controller, it is so small. Besides looking at the picture, I felt a little over both times. To be honest, rumored this button, difficult to push (; ^ ω ^) The button to set auto cruise is the white button in the middle, The buttons of the up and down arrows are capable of raising or lowering the speed by the amount of pressing the button from the set speed, Since the controller may be large, I want you to make it easier to push the button.

Is a small button indispensable for remodeling? !

I'm planning to improve this after installing the button (; '∀') which is difficult to push too much. After setting cruise control, if you can speed up and down comfortably at hand, It seems to be really fun (o ^ - ^ o)

Wait for the dedicated brake harness to be released in August ...

A brake harness corresponding to Siienta Hybrid TSSC will be released in August is. Wait until it comes out or do you wire it directly by yourself. It is a troublesome place, I think that it will actually decide after seeing the car and the car after seeing it. However, I do not feel like I can wait another month (; · · ω ·)

Installation will be DIY!

From next time, installation will begin immediately! I had been looking at various ways of attachment on the net before this Kuron arrived, It gradually comes with knowledge, and it has become a feeling that "Is this possible if you can do it yourself?" When asking for installation somewhere, it seems that it takes more than double this purchase price as a whole (; ^ ω ^)
There is also uneasy about honesty, but I am looking forward to it! (o ^ - ^ o)


■使用カメラ
ボディ：Nikon D7000
レンズ：Nikon 単焦点 AF-S DX Micro NIKKOR 40mm f/2.8G



新型シエンタ　pivotクルコン取り付け記事一覧へ